Low supply voltage
Cause: The voltage at the outlet is too low.
What to do: Have the circuit checked by an electrician.
Home / Tuskegee / Dishwasher repair
Professional repair of wash pumps, drain pumps, inlet valves and heaters. We reach Tuskegee (36083, 36088) in about 50 minutes.
What we hear most in Tuskegee
| Repair | Typical time | |
|---|---|---|
| Circulation pump repair | ~90 min · 3 mo warranty | |
| Drain pump replacement | ~45 min · 3 mo warranty | |
| Water inlet valve replacement | ~45 min · 3 mo warranty | |
| Heating element replacement | ~60 min · 3 mo warranty | |
| Door latch and seal repair | ~40 min · 3 mo warranty | |
| Spray arm and filter cleaning | ~40 min · 1 mo warranty |
Code on the display?
Cause: The voltage at the outlet is too low.
What to do: Have the circuit checked by an electrician.
Cause: The control panel is not communicating with the main control.
What to do: Switch off at the breaker for 5 minutes. If it returns, the panel or ribbon cable needs replacing.
Cause: The thermistor and turbidity sensor is open or shorted.
What to do: The sensor needs replacing.
Cause: The control did not see the door open and close.
What to do: Open and close the door firmly, then press Start. If it returns, the latch needs replacing.
Cause: The inlet valve has an electrical fault.
What to do: The inlet valve needs replacing.
Cause: Too much detergent, hand dish soap, or not enough water.
What to do: Use only dishwasher detergent and check the water supply is fully open.
Typically about 50 minutes after we confirm the booking. You choose a three-hour arrival window and the technician calls before setting off.
The service call is a flat $89 and covers the trip to Tuskegee and a full diagnosis. You then get an exact quote for parts and labor before any work starts.