Water is not draining
Cause: The drain filter is blocked or the hose is kinked.
What to do: Open the filter behind the lower front cover and clean it.
Home / Cusseta / Washer repair
From drum bearings to the control board, we fix every washer fault at your home, right in front of you. We reach Cusseta (36852) in about 45 minutes.
What we hear most in Cusseta
| Repair | Typical time | |
|---|---|---|
| Drum bearing replacement | ~150 min · 3 mo warranty | |
| Door lock / lid switch repair | ~40 min · 3 mo warranty | |
| Water inlet valve replacement | ~40 min · 3 mo warranty | |
| Control board repair | ~90 min · 3 mo warranty | |
| Drive belt replacement | ~30 min · 3 mo warranty | |
| Suspension and shock replacement | ~75 min · 3 mo warranty | |
| Drain pump replacement | ~45 min · 3 mo warranty |
Code on the display?
Cause: The drain filter is blocked or the hose is kinked.
What to do: Open the filter behind the lower front cover and clean it.
Cause: The pressure sensor is not reading correctly.
What to do: The sensor needs testing and replacing if faulty.
Cause: Power was interrupted during the cycle.
What to do: Press Start to resume.
Cause: Too much detergent.
What to do: Wait for the suds to settle. Use less HE detergent.
Cause: The load is too small, too large or bunched up.
What to do: Rearrange the load and make sure the washer is level.
Cause: The door is not fully closed or the lock has failed.
What to do: Close the door firmly. If the code stays, the door lock needs replacing.
Typically about 45 minutes after we confirm the booking. You choose a three-hour arrival window and the technician calls before setting off.
The service call is a flat $89 and covers the trip to Cusseta and a full diagnosis. You then get an exact quote for parts and labor before any work starts.