Water is not draining
Cause: The drain hose is kinked or the filter is clogged.
What to do: Clean the filter and check the drain hose and air gap.
Home / Waverly / Dishwasher repair
Professional repair of wash pumps, drain pumps, inlet valves and heaters. We reach Waverly (36879) in about 40 minutes.
What we hear most in Waverly
| Repair | Typical time | |
|---|---|---|
| Drain pump replacement | ~45 min · 3 mo warranty | |
| Water inlet valve replacement | ~45 min · 3 mo warranty | |
| Heating element replacement | ~60 min · 3 mo warranty | |
| Door latch and seal repair | ~40 min · 3 mo warranty | |
| Spray arm and filter cleaning | ~40 min · 1 mo warranty | |
| Circulation pump repair | ~90 min · 3 mo warranty |
Code on the display?
Cause: The drain hose is kinked or the filter is clogged.
What to do: Clean the filter and check the drain hose and air gap.
Cause: Power was interrupted during the cycle.
What to do: Press Start to resume.
Cause: Hand dish soap or too much detergent was used.
What to do: Let the suds settle, then run a rinse. Use only dishwasher detergent.
Cause: The motor that switches spray arms has failed.
What to do: The diverter motor needs replacing.
Cause: The thermistor is faulty or the water is too hot.
What to do: The thermistor needs testing.
Cause: The drying vent did not close.
What to do: Switch off at the breaker for 5 minutes. If it returns, the vent assembly needs replacing.
Typically about 40 minutes after we confirm the booking. You choose a three-hour arrival window and the technician calls before setting off.
The service call is a flat $89 and covers the trip to Waverly and a full diagnosis. You then get an exact quote for parts and labor before any work starts.