Home / Waverly / Washer repair
From drum bearings to the control board, we fix every washer fault at your home, right in front of you. We reach Waverly (36879) in about 40 minutes.
What we hear most in Waverly
| Repair | Typical time | |
|---|---|---|
| Control board repair | ~90 min · 3 mo warranty | |
| Drive belt replacement | ~30 min · 3 mo warranty | |
| Suspension and shock replacement | ~75 min · 3 mo warranty | |
| Drain pump replacement | ~45 min · 3 mo warranty | |
| Drum bearing replacement | ~150 min · 3 mo warranty | |
| Door lock / lid switch repair | ~40 min · 3 mo warranty | |
| Water inlet valve replacement | ~40 min · 3 mo warranty |
Code on the display?
Cause: A faucet is closed or the inlet hose is kinked.
What to do: Open the faucets, straighten the hoses and rinse the inlet screens. If nothing changes, the inlet valve is faulty.
Cause: The hot water hose is connected to the cold inlet.
What to do: Swap the inlet hoses so cold water feeds the cold inlet.
Cause: The pump filter is full of debris or the pump has failed.
What to do: Drain the water through the emergency drain tube and clean the filter.
Cause: The supply voltage is too low or too high.
What to do: Plug the washer directly into a wall outlet, not an extension cord. If it continues, have the outlet checked.
Cause: The control boards have lost communication.
What to do: Unplug for 5 minutes. If it returns, the boards and wiring need testing.
Cause: The heater or its sensor has failed.
What to do: The heater needs testing and replacing if faulty.
Typically about 40 minutes after we confirm the booking. You choose a three-hour arrival window and the technician calls before setting off.
The service call is a flat $89 and covers the trip to Waverly and a full diagnosis. You then get an exact quote for parts and labor before any work starts.